THE WHITE DOOR EMERGENCY CODE MANUAL
THE WHITE DOOR EMERGENCY CODE CODE

THE WHITE DOOR EMERGENCY CODE CODE

The National Electric Code and NYC Amendments, 110.34, Table A, have quantitative values for side and rear clearances, both for service and distribution equipment. If Necessary, a limited number of devices shall be permitted to be removed to achieve this accessibility. If necessary, a limited number of barriers or covers shall be permitted to be removed to achieve this accessibility.' UL's Marking and Application Guide for Dead-Front Switchboards, January 2012 states in the glossary 'Accessible, Front- An enclosure in which all bus and device connections are accessible from the front. Other connections shall be permitted to be rear or side accessible. Nema Standards Publication PB-2-20 11 defines the following 'An enclosure in which incoming and outgoing field termination points are accessible from the front. The 'rule of thumb' has been 36' or less in depth, with connections & cable terminations within 30' of the front of the enclosure. There is a question as to the physical dimensions of what constitutes Front Accessible Standards.This installation is in violation of section 110.26(A)(3) and 110.26(E) where the minimum headroom shall not be less than the height of the equipment. Does this installation violate section 110.26 Spaces About Electrical Equipment of the NYCEC? In particular, the non-removable cover above the door head jamb. There is 5' working space in front of the removable cover when the electrical closet door is open. There is 6' from the non-removable cover of the panelboard to the inside wall of the electrical closet. Refer to the attached sketch: 20170208-QPRD-SKETCH-PANELBOARD. The removable door cover will be entirely within the door opening. The panelboard will be provided with a non-removable cover 1'-6' from the top of the panelboard. The top of the door opening is 7'-0' AFF. The top of the panelboards are 8'-0' AFF. Electrical work space for these panels is achieved when the electrical closet door is opened. Electrical panelboards serving the apartments will be installed every third floor in each electrical closet. There is a new residential high rise building with two electrical closets located in the corridor of every floor (43 floors).

THE WHITE DOOR EMERGENCY CODE MANUAL

Construction requirements for transformer vaults and network protector compartments, on 265/460 Volt installations, are described in Con Edison Specification EO-5023 of Construction Standards Manual No. A service take-off and/or a 460 Volt disconnect switch may also be included. Network compartment (Network Protector Compartment): Is structure containing a network protector and paralleling bus. No, it is not referring to communication network closet. Section 110.26 of the NYC 2011 Electrical Code Technical Provisions states, 'Add new Subsection 11 0.26(H) All new network compartments shall have at least two means of access.' What is the definition of a network compartment? Is it referring to a communication network closet?.Yes, where double the 1000kVA clearance is provided and a person will not be required to walk in front of electrical equipment to reach all service switches. ' If I have a 4000A Switchboard located in a new buildings electrical room and a working clearance that is twice the required space in front (front only) of the Switchboard, as stated in the 2014 NEC ArticaI110.26(C)(2)(b) Will a single entrance be acceptable for this space? shall be sized to provide the applicable working space requirements. Section 110.25 of the NYC 2011 Electrical Code Technical Provisions states, 'Electrical Closets.

The white door emergency code